The custodian of the ring die of the pellet machine must be serious and responsible. The die hole is processed by the sawdust pellet machine manufacturer with high-speed drilling, and its finish is very high. To ensure maximum output, it is necessary to keep the die hole clean. In addition, the ring die of the wood pellet machine should be stored in the following places.

After the ring die of the sawdust pellet machine is stored for six months, the oily filler inside must be replaced with a new one, because the material inside will become hard when stored for too long, and the pellet machine cannot be pressed out when it is used again, resulting in blockage of the machine. . The ring die should always be placed in a dry, clean and ventilated place.

If you do not use it for a long time, you can apply a layer of waste oil on the surface to prevent the corrosion of moisture in the air.

Generally, there will be a lot of production raw materials in the production workshop. Do not put the ring die in these places, because the material is particularly easy to absorb moisture and is not easy to disperse. If it is placed together with the ring die, it will accelerate the corrosion of the ring die, thereby affecting its service life.

If the ring die needs to be removed for backup during the production process of the sawdust pellet machine, all the raw materials should be extruded with oily material before the machine is shut down, so as to ensure that the die hole can be discharged the next time it is used. If the material is filled, long-term storage will not only cause corrosion of the ring die, because the production raw material contains a certain amount of moisture, which will accelerate the corrosion in the die hole, causing the die hole to be rough and affecting the discharge.